If this doesn't work, change your GameEx setup for ZSNES to Show Desktop: True and try to launch it again.

Then, right click the gens.cfg file, select PROPERTIES and change the check mark to READ ONLY.Ĥ) I don't have ZSNES in front of me, but make sure you open the zsnes.ini file and disable the GUI from there. Go to your gens.cfg file, change that line where it says FULLSCREEN like you did before and save & close it. Most commonly this happens when my Norton kicks in for a scan. When that program comes to the front it minimizes GameEx and I have to maximize it myself before it starts. The minimize problem happens to me if I run something else behind GameEx. I have done a search on the whole forum and nothing has helped me with these problems ( accept the chankex wrapper problem i had - headkaze you da man- ). if that is the case then i cannot get this to work but i have only tried this with zsnes wich i already have a problem with. I thought gameex would unzip the 7zip file and show all the roms within gameex rom menu, then allow you to play the roms even if the emulator does not support 7zip. i have attached the log file from when i try to load zsnes within gameex the problem i get is when i try and load a rom from within gameex the screen goes black for a couple of seconds then it goes back to gameex i have tried almost everything and no joy. I am using the config for this from the configs section, i have changed all of the rom paths/directories. i know i have probably done a noob mistake. I changed this to 1 and it does work in gameex but the moment i exit and start again it has totally forgotten the setting. i edited the cfg file in gens where it says fullscreen=0 or 1 I am having trouble getting this to play full screen. I also tried to use joy2key but virtua tennis only lets you use 1 player for the keyboard. for the lob button i assign button3 for this action, but when i assign the next button ( shoot ) button3 gets assigned to this even though i pressed a different buttonand this happens on players 2-4. i have 4 usb gamepads which i use on my machine which work fine with every other PC game/emulator just fine, but when i try config the buttons it will only work with one of the pads, i.e i configure player 1 just fine but when i try and configure 2-4 the moment i input a command for these it puts the command i used previosly. Sometimes when i open Gameex it opens then automaticallly minimizes itself, in fact this happens a lot, is this a common problem or is it my machine that is the problem, idid look in the log file and there is nothing in there to say that something is wrong. I have a registered version of gameex, i have setup most of the emulators i want with it but i am haveing the following problems.

Zsnes directdraw error